|
|
| (4 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| == Demonstrate DFU usage for DHCOR recovery ==
| |
|
| |
|
| This patch configures U-Boot SPL for DHCOR SoM to permit DFU upload of
| |
| SPL and subsequent u-boot.itb for recovery or commissioning purposes.
| |
| It is not possible to use this SPL build for production due to its
| |
| large size.
| |
|
| |
| Compile U-Boot for the DHCOR Avenger96 target:
| |
| $ make stm32mp15_dhcor_basic_defconfig
| |
| $ make -j`nproc`
| |
|
| |
| - Install dfu-util on the host PC (in debian this is package 'dfu-util')
| |
|
| |
| - Power off the Avenger96 board.
| |
|
| |
| - Connect both USB-serial console and USB-OTG microB ports to host PC.
| |
|
| |
| - Switch Avenger96 to USB boot mode -- BOOT0..2 switches all set to 0.
| |
|
| |
| - Power on the Avenger96 board.
| |
|
| |
| - Verify using '$ dmesg' that a new device has been detected as follows:
| |
|
| |
| New USB device found, idVendor=0483, idProduct=df11, bcdDevice= 2.00
| |
| New USB device strings: Mfr=1, Product=2, SerialNumber=3
| |
| Product: DFU in HS Mode @Device ID /0x500, @Revision ID /0x0000
| |
| Manufacturer: STMicroelectronics
| |
|
| |
| - Upload U-Boot SPL:
| |
| $ dfu-util -a 1 -D u-boot-spl.stm32
| |
| - Upload U-Boot proper:
| |
| $ dfu-util -a 0 -D u-boot.itb
| |
|
| |
| At this point, SPL will wait for user to press "Ctrl-C" on serial console. When ready to interact with U-Boot, press Ctrl-C to start the bootloader.
| |
|
| |
| Note that this is adapted from ST article, with removed requirement for custom DFU implementation and additional bootloader components, which are not required on this platform:
| |
| https://wiki.st.com/stm32mpu/wiki/How_to_load_U-Boot_with_dfu-util
| |
|
| |
| Signed-off-by: Marek Vasut's avatarMarek Vasut <marex@denx.de>
| |
