DHCOM How to use the Update Mechanism

This guide describes how to properly update the built-in flash or eMMC memory on DHCOM devices with a provided update zip file.

Required hard- and software

• DHCOM Update files mostly provided as zip file (If you don't have the needed update files, please ask DH electronics)
• Windows / Linux computer or virtual machine with a administrative account
• Empty USB stick with at least 1 GB capacity
• DHCOM i.MX6 / i.MX25 / AM335x / AM35xx
• Baseboard with USB port like PDK2 / picoITX2 / DRC02

Prepare a USB stick or SD card for the update process

The bootloader update mechanism expects a single FAT32 partition on a storage device such as a USB stick or SD card.

Make the USB stick available in your system by connecting it to your computer. If you work with a virtual machine, then connect the newly connected USB stick to your virtual machine.

Linux

This step by step guide has been developed and tested with the Virtual Machine for Application Development from DH electronics and should also work with gparted on other linux distros.

Open GParted and select device

• Open the disk utility GParted

Note: You will be asked for your user password to gain super user right through sudo.

• Choose your device in the drop down menu right at the top of the user interface

Warning: Be sure that you have selected the correct device for the following steps.

Check current partition table and partition format

• Verify that you already have a DOS partition table and that the first partition is formatted as FAT32 by selecting Device Information in the View menu

• If you see Partition table: msdos and File System: fat32 your USB stick is already prepared for the Update Mechanism and you can head over to #Place Update Files on the USB stick
• If you only see Partition table: msdos head over to #Create FAT32 formatted partition
• And if you don´t see anything like in the picture follow the next steps

Create DOS partition table

Warning: The following steps will cause data loss on the selected device!

• Create a empty dos partition table with Create Partition Table in the Device menu and ensure you select msdos as type.

Create FAT32 formatted partition

Warning: The following steps will cause data loss on the selected device!

• Remove any existing partition by selecting them and choosing Delete in Partition menu
• Create a FAT32 formatted partition with New in the Partition menu and ensure you select File system: fat32.

• Apply all operations to write changes to disk

Windows

This step by step guide has been developed and tested with Windows 10 Professional Version 1809 and should also work with Windows 7/8 and similar.

Open Disk Management

• Press the Windows button, type compmgmt.msc and start the Microsoft Service Console as administrator by Run as administrator in the right-click menu.

• In the tree view on the left side of the window, select Disk Management in the section Storage.

Check current partition table and partition format

• Open the dialog Properties with a right-click on the device

• Check for Partition style: Master Boot Record (MBR) in the Volumes tab

If you don´t see Partition style: Master Boot Record (MBR) follow Convert to MBR using a command line and continue with #Create FAT32 partition afterwards

• Check for File system: FAT32 in the General tab of the Properties windows of the Volume

If you don´t see File system: FAT32 continue at #Remove existing partitions

• Congratulations your USB stick is already prepared for the Update Mechanism and you can head over to #Place Update Files on the USB stick

Remove existing partitions

Warning: The following steps will cause data loss on the selected device!

• Create a empty dos partition table with Create Partition Table in the Device menu and ensure you select msdos as type.

Create FAT32 partition

Warning: The following steps will cause data loss on the selected device!

• Create a empty dos partition table with Create Partition Table in the Device menu and ensure you select msdos as type.