|
|
Line 1: |
Line 1: |
| [[Image:Page Under Construction.png|600px|DHCOM STM32MP1-D2]]
| |
|
| |
| {| | | {| |
| | | | | |
Revision as of 09:41, 5 October 2021
Hardware
|
|
- Dual ARM Cortex®-A7 up to 650 MHz and Single ARM Cortex®-M4 up to 209 MHz
- 3D GPU OpenGL® ES2.0 up to 533 MHz, Power Management: STPMIC1A
- TrustZone, cryptography, hash, secure boot
- DDR3L: 256 / 512 / 1024 Mbyte (32 bit)
- eMMC flash: 4 / 8 / 16 GB
- 2 MByte SPI boot flash
- 256 byte EEPROM
- WiFi / Bluetooth: WiFi IEEE 802.11 a/b/g/n, 802.11j (hosted mode) with dual band, Bluetooth® v5.0 (BR/EDR/BLE), PCB antenna and U.FL antenna connector
- On-board microSD card socket
- RTC with temperature compensation ± 3.0 ppm between -40 to +85°C
- Supply voltage range: 3.3 or 5.0 VDC / typ. 1 W-1.5 W (without WiFi/BT)
- Industrial temperature range (-40°C to +85°C)
- SODIMM-200 socket with DHCOM pin assignment
- JTAG debug connection via FFC plug connector or Tag-Connect
- Bus interface: 16 bit asynchron address/data bus, 1 CS
- Ethernet 1: 10 / 100 Mbit with PHY, IEEE 1588v2
- Ethernet 2: 10 / 100 Mbit with PHY
- MMC/SD interface: 4 bit mode
|
- CAN 1: V2.0B and CAN FD V1.0, TTCAN (time triggered)
- CAN 2: V2.0B and CAN FD V1.0
- UART 1: Rx / Tx / Rts / Cts, up to 12.5 Mbit/s
- UART 2: Rx / Tx / Rts / Cts, up to 12.5 Mbit/s
- UART 3: Rx / Tx, up to 12.5 Mbit/s
- SPI 1: max. 50 Mbit/s
- I2C 1: max. 1 Mbit/s
- I2C 2: max. 1 Mbit/s
- USB host 1: High-Speed
- USB OTG: High-Speed
- Parallel camera: 10 bit interface up to 140 Mbytes/s
- Display RGB: Max. 1366 x 768 pixels, 24 bit
- MIPI®-DSI 2 data lanes up to 1 GHz each
- Touch: 4-wire
- I²S Audio interface
- GPIOs: 24 IOs
- PWM: 1x 16 bit
- Analog: 4x 16 bit ADC and 2x 12 bit DAC
|
Product Change Notifications (PCN)
Software Support
BSP Sources
Download binaries/images
Note: Based on kernel 5.10.x and Yocto version dunfell