USB Mass Storage Gadget (or MSG)

The USB Gadget File-backed Storage Driver implements the USB MAss Storage class. The System appears to the host as a SCSI disk drive. A file or a block device is used as a backing store for the drive.

General Information

For further information about details of the USB Gadget File-backed Storage Driver have a look at www.linux-usb.org/gadget/file_storage.html. It is possible to work with kernel-modules. The steps below descripe how to compile the driver statically into the kernel because it is easier to handle.

Configure the USB-OTG Port

To use USB Gadget features the USB-OTG Port has to be initialized in USB slave mode. Add "otg_mode=device" to the kernel commandline on the bootloader console.

On DHCOM boards it is possible to use the u-boot environment variable "linux_add_param":

1. enter bootloader console with DEL/BS Key
2. setenv linux_add_param otg_mode=device
3. saveenv

Prepare the Kernel

Prepare the Linux Kernel Sources to be able to compile.

Open a console window and go to the root directory of the kernel sources and start the kernel configuration dialog:

• ARCH=arm CROSS_COMPILE=arm-none-linux-gnueabi- make menuconfig

Enable the following items:

• Device Drivers --> USB Support --> USB Gadget Support
• Device Drivers --> USB Support --> USB Gadget Support --> USB Peripheral Controller

choose the matching device controller:

* DHCOM AM35x: OMAP USB Device Controller

* DHCOM iMX25: Freescale Highspeed USB DR Peripheral Controller

• Device Drivers --> USB Support --> USB Gadget Support --> USB Gadget Drivers --> File-backed Storage Gadget

Apply the following changes to the file linux-2.6.38/drivers/usb/gadget/file_storage.c in the lines 332 and 333:

- .removable        = 0,
- .can_stall        = 1, 
+ .removable        = 1, // old value = 0,
+ .can_stall        = 0, // old value = 1, 

Start building the kernel:

• ARCH=arm CROSS_COMPILE=arm-none-linux-gnueabi- make uImage

Install the kernel on your board.

Using USB Gadget File-backed Storage

On the running device you can use the following line to add the FAT32 partition of the microSD-card to the usb gadget driver:

• i.mx25# echo /dev/mmcblk0p1 > /sys/devices/platform/fsl-usb2-udc/gadget/gadget-lun0/file

If you do not work the i.mx25 maybe there are some tiny differences in the path of the sysfs.   If you connect the USB-OTG port now the specified device appears as a drive on your host pc.   Remark:

• If you run windows then you can only use block devices with filesystems supported by windows (FAT32).
• Do not use the rootfilesystem partition of your microSD card. This will cause damage to the used microSD-Card partition.

  Have a look at [| www.linux-usb.org/gadget/file_storage.html] to get a step by step guide how to work with „Backing Storage Files“.