DHCOM How to use the Update Mechanism

From Wiki-DB
Jump to navigationJump to search

This guide describes how to properly update the built-in flash or eMMC memory on DHCOM devices with a provided update zip file.

Required hard- and software

  • DHCOM Update files mostly provided as zip file (If you don't have the needed update files, please ask DH electronics)
  • Windows / Linux computer or virtual machine with a administrative account
  • USB stick with at least 1 GB capacity
  • DHCOM i.MX6 / i.MX25 / AM335x / AM35xx
  • Baseboard with USB port like PDK2 / picoITX2 / DRC02

Prepare a USB stick or SD card for the update process

The bootloader update mechanism expects a single FAT32 partition on a storage device such as a USB stick or SD card.

Make the USB stick available in your system by connecting it to your computer. If you work with a virtual machine, then connect the newly connected USB stick to your virtual machine.

Linux

This step by step guide has been developed and tested with the Virtual Machine for Application Development from DH electronics and should also work on other linux distros.

Prepare for the next steps

  • Open a local terminal
  • Gain super user rights with sudo su or su
  • Identify your device with dmesg
Our newly attached USB stick has the device name sde which results in the device file /dev/sde.
To be on the safe side we use in all following commands the non existent device /dev/sdX.
Replace /dev/sdX with your specific device in all following commands.

Check current partition table and partition format

  • Check if you have already a DOS partition table and if the first partition is formatted as FAT32 with file -s /dev/sdX1

Create DOS partition table and FAT32 partition

  • Create empty dos partition table and one full size primary partition with fdisk /dev/sdX
Note: As fdisk is a interactive utility, you have to enter the red printed commands manually.
Note: If you see a question like "Do you want to remove the signature?", it does not matter if you answer with yes or no.
  • Format the new partition with mkfs.vfat /dev/sdX1

Place Update Files on the USB stick