DHCOM STM32MP1 Linux

From Wiki-DB
Jump to navigationJump to search

Kernel Userspace Interfaces to Access Hardware

RS-485 on picoITX

RS-485 device
DHCOM UART 2 /dev/ttySTM2
Compilation on target
gcc tty_rs485_test.c -o tty_rs485_test
Set tty device to raw mode
stty -F /dev/ttySTM2 115200 cs8 raw -echo
Send data with demo program
./tty_rs485_test /dev/ttySTM2
Receive data with demo program
./tty_rs485_test /dev/ttySTM2
Download example source code

CAN interface

Setup CAN interface with baudrate 500kbit/sec.
ip link set can0 up type can bitrate 500000
Start to listen on CAN port
candump can0
Send test message
cansend can0 100#11.2233.44556677.88
Deinitialize CAN port
ip link set can0 down