DHSBC STM32MP13: Difference between revisions

Revision as of 17:18, 5 August 2024

The DHSBC STM32MP13x board is the official DHCOR STM32MP13 reference design!


Contents 1 Introduction 2 Technical Details 3 Product Change Notifications (PCN) 3.1 DHCOR STM32MP13 4 Downloads 5 Documentation 6 Design Files 7 Software 7.1 DH Mainline based Linux 8 Useful instructions 8.1 Setup new board and install image files via USB (dfu and ums mode) / U-Boot recovery via DFU

Reference design for secure industrial IoT devices based on STM32MP13x


STM32MP135F 1x ARM® Cortex-A7 up to 1 GHz PMIC STPMIC1D DDR3 DRAM 512 Mbyte @ 533 MHz eMMC Flash 4 Gbyte NOR Flash 4 Mbyte, Quad SPI interface EEPROM 4 kbyte RTC temp. compensated RV-3032-C7 USB Host 1x type A, 2.0 high-speed USB Device 1x Type-C, 2.0 high-speed WiFi / Bluetooth WiFi 2.4GHz IEEE 802.11b / g / n Bluetooth® v5.2 (BR/EDR/BLE) Antenna: U-FL connector Ethernet 10 / 100 / 1000 Mbit/s, IEEE 802.3-compliant	TPM (Trusted Platform Module)2.0 device ST33TPHF2XSPI Push-Buttons Power and reset Battery Socket CR1216, CR1220 and CR1225 Boot Mode 3 bit boot mode switch Debug Interface JTAG interface via tag-connect Supply (SYS_DCIN) 8 - 18 VDC Temperature Range 0 - 40 °C Dimensions 85 x 56 mm Raspberry Pi 40-pin Expansion 2 x UART 1 x I2C 1 x I2S 1 x SPI 2 x PWM 2 x CAN up to 28 x GPIOs

@@ Line 82: / Line 82: @@
 * [https://github.com/dh-electronics/kas-dhsom Build your own Yocto Scarthgap LTS via kas (GitHub)]
 * [https://github.com/dh-electronics/meta-dhsom-stm32-bsp Yocto BSP meta layer (Github)]
+== Useful instructions ==
+==== Setup new board and install image files via USB (dfu and ums mode) / U-Boot recovery via DFU ====
+*[[DHSBC STM32MP13 DFU and UMS uasge |DHSBC STM32MP13 DFU and UMS uasge]]